Image
Removing a board installed with removable clips
Do you need to remove a board that has been fixed in with our removable clip?
The clip is designed so that the screw is accessible with a standard Torx T15 bit.
Slightly loosen the clip and shift it to position the screw head above the “lock hole”.
Image
Installing an edge board
Edge boards can be fixed with start and end clips.
These clips are screwed to the joist from the side or above (e.g. decking edge against a wall).
They secure the peripheral boards without exposed screws.
Image
Cutting an Atmosphere board
Tips? Cutting suggestions for the Atmosphere co-extruded range for decking
Image
Fascia board
Looking for the right final touches for your decking creation? Allow us to suggest the fascia board accessory.
Before fitting fascia boards, the fixed deck boards must be trimmed to an even finish using a straight-edge and a circular saw.
Image
Space between boards
How much space should be left between your deck boards?
It is essential to leave a gap of at least 5 mm in width.
This allows boards to expand with changes in temperature, and also enables water and melting snow/ice to drain away.
This gap between boards must not be obstructed.